Basically i've built the compy. I turn it on, and it seems to boot up fine. Tested the DVD-drive and that pops in and out just fine. However, my monitor displays the fact that there is "no signal detected". The relevant cable is plugged in from monitor to pc, as is the power cable from graphics card to PSU, yet still nothing happens. I also get no "bleeping" from the computer at all (not sure whether this was related to this problem). I've triple-checked the power cables inside the computer and they all are connected properly. I just can't seem to think what the problem is if it isn't that.
Your help would be greatly appreciated. Thank you for reading.
